Who Knows How To Install Ultra-slim-acrylic-letter?

The installation method of ultra-slim-acrylic-letter is as follows;
1. The first tools we need to prepare are glass glue, tape measure, utility knife, screwdriver, and masking paper. The equipment we need is a power supply, wires, switches.
2. Before installing ultra-slim-acrylic-letter, we must first consider what structure we are installing and the wall. We prepare light steel keel structure, 75-type keel, 9mm wooden board, and tempered glass on it. Before the design, we have already drilled the opening positions required for the font in the tempered glass before leaving the factory. What needs to be tested for this hole is the early design, and the factory communication in the later stage, the hole should not have the slightest deviation, otherwise the tempered glass will be useless.
3. Before installing the glass, what we did was to dig a slot on the board (as shown in the picture below), and put the power supply and wires in it. Then, pass the wires through the tempered glass. These tasks seem to be done by sight, but it may take a lot of effort to connect them. Whether it is the installation of glass or the installation of luminous characters, our installation masters have a unique set of methods after extensive experiments in advertising production and installation.

4. Before installing the glass, be sure to connect the wires clearly, and there must be no sloppy, otherwise, after the glass is installed, there is no way to take pictures of the installation wires. Technology is a measure to test the installation level of a master. Separate the positive and negative poles in the wiring, and be careful every step of the way. Connect the positive and negative poles of the wire head in parallel and put them in front of the glass opening
5. After a long period of wire connection, we started to install the ultra-slim-acrylic-letter. At this time, to install the advertising characters, just connect the positive and negative poles of the characters to the openings of the parallel wires.
6. After connecting the wires, apply glass glue on the bottom of the backlight characters on the tempered glass, and adjust the installation angle of the characters. In this way, the ultra-slim-acrylic-letter are installed one by one.